Extreme Networks EAS 200-24p Switch, Руководство пользователя

Страница: 264 / 908

Chapter 16: Configuration Command List
Extreme Networks EAS 200-24p Switch CLI Manual
264
show config
Description
Display the content of the current configuration, the configuration to be used in next boot, or the
configuration file specified by the command.
The output stream of the configuration data can be filtered by the expression specified at the end of the
command. The expression can contain up to three multiple filter evaluations. A filter evaluation begins
with a filter type (include, exclude, and begin), followed by up to three filter strings (ex: “stp”). A filter
string is enclosed by symbol ". The following describes the meaning of the each filter type.
●
include: includes lines that contain the specified filter string.
●
exclude: excludes lines that contain the specified filter string
●
begin: The first line that contains the specified filter string will be the first line of the output.
The relationship of multiple filter strings following the same filter type is OR. That is, one line is
qualified if one of specified filter strings is matched.
If more than one filter evaluation is specified; the output of filtered by the former evaluation will be
used as the input of the latter evaluation.
Format
show config [effective | modified | current_config | boot_up | file <pathname
64>] {[include | exclude | begin] <filter_string 80> {<filter_string 80>
{<filter_string 80>}} {[include | exclude | begin] <filter_string 80>
{<filter_string 80> {<filter_string 80>}} {[include | exclude | begin]
<filter_string 80> {<filter_string 80> {<filter_string 80>}}}}}
Parameters
●
effective - Show only commands which affects the behavior of the device. For example, if STP is
disabled, then for STP configuration, only “STP is disabled” is displayed. All other lower level
setting regarding STP is not displayed. The lower level setting will only be displayed when the
higher level setting is enabled.
NOTE
This parameter is only for the current configuration.
●
modified - Show only the commands which are not from the ‘reset’ default setting.
NOTE
This parameter is only for the current configuration.
●
current_config
- Specifies the current configuration.
●
boot_up
- Specifies the list of the bootup configuration.