Extreme Networks EAS 200-24p Switch, Руководство пользователя

Страница: 187 / 908

config egress_flow_meter
Extreme Networks EAS 200-24p Switch CLI Manual
187
config egress_flow_meter
Description
This command is used to configure the packet flow-based metering based on an egress access profile
and rule.
Format
config egress_flow_meter [profile_id <value 1-4> | profile_name <name 1-32>]
access_id <value 1-128> [rate [<value>] {burst_size [<value>]} rate_exceed
[drop_packet | remark_dscp <value 0-63>] | tr_tcm cir <value> {cbs <value>}
pir <value> {pbs <value>} {[color_blind | color_aware]} {conform [permit |
replace_dscp <value 0-63>] {counter [enable | disable]}} exceed [permit
{replace_dscp <value 0-63>} | drop] {counter [enable | disable]} violate
[permit {replace_dscp <value 0-63>} | drop] {counter [enable | disable]} |
sr_tcm cir <value> cbs <value> ebs <value> {[color_blind | color_aware]}
{conform [permit | replace_dscp <value 0-63>] {counter [enable | disable]}}
exceed [permit {replace_dscp <value 0-63>} | drop] {counter [enable |
disable]} violate [permit {replace_dscp <value 0-63>} | drop] {counter [enable
| disable]} | delete]
Parameters
●
profile_id - Specifies the profile ID.
●
<value 1-4> - Enter the profile ID used here. This value must be between 1 and 4.
●
profile_name - Specifies the name of the profile. The maximum length is 32 characters.
●
<name> - Enter the profile name used here.
●
access_id - Specifies the access ID.
●
<value 1-128> - Enter the access ID used here. This value must be between 1 and 128.
●
rate - This specifies the rate for single rate two-color mode. Specify the committed bandwidth in
Kbps for the flow. The value m and n are determined by the project.
●
<value> - Enter the rate for single rate two-color mode here.
●
burst_size - (Optional) This specifies the burst size for the single rate “two color” mode. The unit is
Kbytes.
●
<value> - Enter the burst size value here.
●
rate_exceed - This specifies the action for packets that exceed the committed rate in single rate “two
color” mode. The action can be specified as one of the following:
●
drop_packet - Drop the packet immediately.
●
remark_dscp - Mark the packet with a specified DSCP. The packet is set to have the higher drop
precedence.
- <value 0-63> - Enter the remark DSCP value here. This value must be between 0 and 63.
●
tr_tcm - Specify the “two rate three color mode”.
●
<value> - Enter the two rate three color mode value here.
●
cbs - (Optional) Specifies the “Committed Burst Size”. The unit is Kbytes. That is to say, 1 means
1Kbytes. This parameter is an optional parameter. The default value is 4*1024.