Extreme Networks EAS 200-24p Switch, Руководство пользователя

Страница: 163 / 908

config flow_meter
Extreme Networks EAS 200-24p Switch CLI Manual
163
●
profile_name - Specifies the name of the profile. The maximum length is 32 characters.
●
<name 1-32> - Enter the profile name used here.
●
access_id - Specifies the access ID.
●
<value 1-256> - Enter the access ID used here. This value must be between 1 and 256.
●
rate - This specifies the rate for single rate two color mode. Specify the committed bandwidth in
Kbps for the flow. The value m and n are determined by the project.
●
<value 0-1048576> - Enter the rate for single rate two color mode here. This value must be
between 0 and 1048576.
●
burst_size - (Optional) This specifies the burst size for the single rate two color mode. The unit is
Kbytes.
●
<value 0-131072> - Enter the burst size value here. This value must be between 0 and 131072.
●
rate_exceed - This specifies the action for packets that exceeds the committed rate in single rate, two
color mode.
●
drop_packet - Drop the packet immediately.
●
remark_dscp - Mark the packet with a specified DSCP. The packet is set to have a high drop
precedence.
- <value 0-63> - Enter the remark DSCP value here. This value must be between 0 and 63.
●
tr_tcm - Specifies the “two rate three color mode”.
●
cir - Specifies the “Committed Information Rate”. The unit is in Kbps. CIR should always be equal or
less than PIR.
●
<value 0-1048576> - Enter the committed information rate value here. This value must be
between 0 and 1048576.
●
cbs - (Optional) Specifies the “Committed Burst Size”. The unit is Kbytes. That is to say, 1 means
1Kbytes. This parameter is an optional parameter. The default value is 4*1024.
●
<value 0-1048576> - Enter the commit ed burst size value here. This value must be between 0 and
1048576.
●
pir - Specifies the “Peak Information Rate”. The unit is in Kbps. PIR should always be equal to or
greater than CIR.
●
<value 0-1048576> - Enter the peak information rate value here. This value must be between 0
and 1048576.
●
pbs - (Optional) Specifies the “Peak Burst Size”. The unit is in Kbytes. This parameter is an optional
parameter. The default value is 4*1024.
●
<value 0-131072> - Enter the peak burst size value here. This value must be between 0 and
131072.
●
color_blind - (Optional) Specifies the meter mode as color-blind. The default is color-blind mode.
●
color_aware - (Optional) Specifies the meter mode as color-aware. The final color of the packet is
determined by the initial color of the packet and the metering result.
●
conform - (Optional) Specifies the action when a packet is mapped to the “green” color.
●
permit - Permits the packet.
●
replace_dscp - Changes the DSCP of the packet.
- <value 0-63> - Enter the replace DSCP value here. This value must be between 0 and 63.
●
counter - (Optional) Specifies the ACL counter. This is optional. The default is “disable”. The
resource may be limited so that a counter cannot be turned on. Counters will be cleared when the
function is disabled.