Extreme Networks Altitude 4700 Series, Руководство по продукции

Страница: 584 / 648

Configuring Mesh Networking
Altitude 4700 Series Access Point Product Reference Guide
584
Extreme Networks recommends assigning a unique name to a WLAN supporting a mesh network to
differentiate it from WLANs defined for non mesh support. The name assigned to the WLAN is
what is selected from the
Radio Configuration screen for use within the mesh network.
NOTE
It is possible to have different ESSID and WLAN assignments within a single mesh network (one set
between the Base Bridge and repeater and another between the repeater and Client Bridge). However, for ease
of management and to not waste network bandwidth, Extreme Networks recommends using the same ESSID
across the entire mesh network.
4 Use the Available On checkboxes to specify the Access Point radio(s) used with the target WLAN
within the mesh network.
The Available On checkboxes are for making this WLAN available for base bridges or repeaters to
connect to. The Available On checkbox should only be selected for a mesh WLAN if this target
Access Point is to be configured as a base bridge or repeater on the radio. If the WLAN is to be
defined for client bridge support only, the Available On checkbox should not be selected. Instead, it
only needs to have the Enable Client Bridge Backhaul option selected.
5 Use the Maximum MUs field to define the number of MUs allowed to associate with this WLAN.
This number should be defined based on the number of client bridge and repeaters within this mesh
network. This value can be increased as the mesh network grows and devices are added.
Only advanced users should define the number of devices allowed to associate with the WLAN, as
setting the value too low could restrict devices from joining an expanding mesh network, and setting
it too high could prohibit other WLANs from granting access to the all the devices needed.
6 Select the Enable Client Bridge Backhaul checkbox to make this WLAN available in the Mesh Network
Name drop-down menu within the Radio Configuration screen. Only WLANs defined for mesh
networking support should have this checkbox selected, in order to keep the list of WLANs available
(within the Radio Configuration screen) restricted to just WLANs configured specifically with mesh
attributes.
7 Refer to the Security Policy drop-down menu to select the security policy used within this WLAN
and mesh network.
A security policy for a mesh network should be configured carefully since the data protection
requirements within a mesh network differ somewhat compared to a typical wireless LAN.
No
Encryption is a bad idea in a mesh network, since mesh networks are typically not guest networks,
wherein public assess is more important than data protection. Extreme Networks also discourages
user-based authentication schemes such as Kerberos and 802.1x EAP, as these authentication schemes
are not supported within a mesh network.
If none of the existing policies are suitable, select the Create button to the right of the Security Policy
drop-down menu and configure a policy suitable for the mesh network. For information on
configuring a security using the authentication and encryption techniques available to the
Access Point, see
“Enabling Authentication and Encryption Schemes” on page 200 .
8 ACL policies should be configured to allow or deny a range of MAC addresses from interoperating
with the WLAN used with the mesh network. ACLs should be defined based on the client bridge
and repeater (an Access Point defined as both a base and client bridge) association requirements
within the mesh network.
For information on defining an ACL for use with the WLAN assigned to the mesh network, see
“Configuring a WLAN Access Control List (ACL)” on page 153 .