Extreme Networks Altitude 4700 Series, Руководство по продукции

Страница: 53 / 648

Altitude 4700 Series Access Point Product Reference Guide
53
6 If required, install and attach a security cable to the Access Point’s lock port.
7 Attach the antennas to their correct connectors.
For more information on available antennas, see “Antenna Options” on page 47 .
8 Place the large center opening of each of the mount slots over the screw heads.
9 Slide the Access Point down along the mounting surface to hang the mount slots on the screw heads.
CAUTION
Ensure you are placing the antennas on the correct connectors to ensure the successful operation of the
Access Point.
NOTE
It is recommended the Access Point be mounted with the RJ45 cable connector oriented upwards or
downwards to ensure proper operation.
10
Cable the Access Point using an approved line cord and power supply.
For standard 48-Volt Power Adapter and line cord installations:
a
Connect an RJ-45 CAT5e (or CAT6) Ethernet cable between the network data supply (host) and
the Access Point’s GE1/POE port.
b
Verify the power adapter is correctly rated according the country of operation.
c
Connect the power supply line cord to the power adapter.
d
Attach the power adapter cable into the power connector on the Access Point.
e
Plug the power adapter into an outlet.
11
Verify the behavior of the Access Point’s LEDs. For more information, see “LED Indicators” on
page 57 .
The Access Point is ready to configure. For information on an Access Point default configuration, see
“Getting Started” on page 63 . For specific details on system configurations, see “System Configuration”
on page 77 .
Suspended Ceiling T-Bar Installations
A suspended ceiling mount requires holding the Access Point up against the T-bar of a suspended
ceiling grid, and twisting the chassis onto the T-bar.
The mounting tools (customer provided) and hardware required to install the Access Point on a ceiling
T-bar consists of:
●
Safety wire (recommended and customer supplied)
●
Security cable (and customer supplied)
To install the Access Point on a ceiling T-bar:
1 Extreme Networks recommends you loop a safety wire—with a diameter of at least 1.01 mm (.04
in.), but no more than 0.158 mm (.0625 in.)—through the tie post (above the console connector) and
secure the loop.
2 If desired, install and attach a security cable to the Access Point’s lock port.