Extreme Networks Altitude 4700 Series, Руководство по продукции

Страница: 52 / 648

Hardware Installation
Altitude 4700 Series Access Point Product Reference Guide
52
To mount the Access Point on a wall use the following template:
1 Photocopy the template (on the previous page) to a blank piece of paper. Do not reduce or enlarge
the scale of the template.
CAUTION
If printing the mounting template (on the previous page) from an electronic PDF, dimensionally confirm the
template by measuring each value for accuracy.
2 Tape the template to the wall mounting surface.
●
If the installation requires the antenna be positioned vertically, the centerline reference (of the
template) needs to be positioned vertically. The cabling shall exit the Access Point in a vertical
direction.
●
If the installation requires the antenna be positioned horizontally, the vertical centerline (of the
template) needs to be positioned horizontally. The cabling shall exit the Access Point in a
horizontal direction.
3 At mounting targets A and B, mark the mounting surface through the template at the target center.
4 Discard the mounting template.
5 At each point, drill a hole in the wall, insert an anchor, screw into the anchor the wall mounting
screw and stop when there is 1mm between the screw head and the wall.
If pre-drilling a hole, the recommended hole size is 2.8mm (0.11in.) if the screws are going directly
into the wall and 6mm (0.23in.) if wall anchors are being used.