Excelsior-HENDERSON HCX 1999, Руководство по обслуживанию

Страница: 272 / 474

6-26
6999-0003 7/15/99
CYLINDER HEAD/CAM DRIVE
(StepNumber)
(StepNumber)
(StepNumber)
(StepNumber)
44. Lubricate the camshaft journals with a molybdenum oil
solution. Lubricate the camshaft journal holder and bearing
caps with engine oil.
45. Place the camshafts in their respective journal holders
and align the camshaft timing marks with the idler gear timing
marks as shown.
Notice
The camshafts are stamped either “IN” for intake, or “EX”
for exhaust on the end opposite the gear.
1. CAMSHAFT TIMING MARK 2. IDLER GEAR TIMING
MARKS
46. Install the camshaft bearing caps and tighten the
mounting bolts evenly in a diagonal sequence.
Torque: 90 in-lbs
Notice
To aid in returning the camshaft bearing caps to their
original location they are cast with a number that
matches a number/location cast in the cylinder head. The
arrow head near the number on the bearing cap should
point toward the camshaft gear.
1. CAMSHAFT JOURNAL
CAPS (4)
2. NUMBER/LOCATION ON
CYLINDER HEAD
47. Check to make sure all the rear cylinder timing/index
marks are aligned. Adjust if necessary.
48. Install the hollow dowels for the idler bearing carrier.
49. Install the idler bearing carrier and tighten the mounting
bolts.
Torque: 8 ft-lbs
50. Install the scavenger pump (see OIL SCAVENGE PUMP
page 3-7) .
51. Install the hollow dowels for the timing cover.
52. Install the timing cover with a new gasket and O-ring.
Tighten the mounting bolts in a crisscross pattern.
Torque: 8 ft-lbs
53. Install the primary drive cover with a new gasket. Tighten
the mounting bolts in a crisscross pattern.
Torque: 8 ft-lbs
NEED ART