Exakt EC-310-N, Руководство пользователя

Страница: 2 / 40

1

EXAKT Precision Tools Ltd. 2009
English
Warning Read all safety warnings and all
instructions. Failure to follow the warnings and instructions
may result in electric shock, fire and/or serious injury.
Save all warnings and instructions for future
reference.
Safety Warnings –
Instructions for Putting Into Use
Setting up the Saw for Use
After unpacking check that there are no parts missing or
damaged. If there are contact supplier and do not operate.
Before using a blade needs to be fitted as described in the
operating instructions. (See Blade Changing Section) A
cardboard packing disk may be fitted in place of the blade,
which will need to be removed.
Information on Power Supply
This equipment should be connected to a normal domestic
socket outlet with a voltage rating between 210 and 250 V
and a current rating of between 13 and 16A.
Illustrated Description of Functions
1. Baseplate 6. and 7. Air vents
2. Guard lock (not shown) 8. Dust extract nozzle
3. Depth adjuster knob 9. Cutting width marks
4. Switch 10. Guard removal screw
5. Handle 11. Saw blade
List of contents
 1x EXAKT Precision Saw  1x Torx key & 1x U key
 Blades (dependant on kit)  1x Spare safety washer

1x Standard blade guard

1x Dust extraction hose
 1x Instruction manual  1x Storage case
Safety Warnings – Operating Instructions
This tool should always be used with the dust hose
connected and attached to a suitable vacuum cleaner/dust
extractor.
Setting the Cutting Depth
1. The depth of cut can be set in millimetres by turning the
depth control knob.
(Diagram A)
2. The depth scale has long lines representing whole
millimetres and short lines for half millimetres. To set for
whole millimetres align the bottom edge of the depth
control knob on a long line and read off the number that
is just completely exposed.
3. When cutting wood the depth of cut should be set to
slightly greater than the thickness of the material for best
results.
4. When cutting plastics the depth of cut should be set to
slightly greater than the thickness of the material. If
melting occurs a greater depth setting will improve
results.
5. When cutting metals the depth of cut should be set to
approximately 1.0 mm greater than the material
thickness for best results.
If it is desirable not to mark the surface beneath the
workpiece, the depth can be set to the same as the material
thickness, when cutting wood or plastics, but this may result
in a rough edge.
NB. If the depth control knob becomes difficult to turn,
unscrew it until the rubber seal can be seen. Clean the
surrounding area with a soft brush and then apply a
very small quantity of synthetic grease to the seal.
Blade Changing
NB. Incorrect positioning of the blade can permanently
damage the tool.
1. Ensure the tool is unplugged from the mains supply.
2. Unscrew the depth adjuster until the number 12 is
visible.
3. Without removing the guard insert the U key into the
blade shaft to lock it.
(Diagram B ) Slide off the
removable cover, insert the torx key into the blade
retaining screw and unscrew clockwise.
(Diagram C)
4. Depress the guard to remove the blade.
5. Place the new blade onto the blade shaft ensuring the
hole locates correctly and the teeth point forwards in the
direction of the curved arrow.
(Diagram C)
6. Replace the safety retaining washer and tighten the
screw.
(Diagram D)
7. Remove both keys before plugging in.