EVS XSnano, Руководство по настройке, Страница: 22 / 198

2.2.2. Launching a Configuration
Introduction
When the EVS server has initialized, the Multicam Setup window stays open, by default,
until the operator selects the requested configuration line and launches it.
Multicam can encode the video signal simultaneously in several essences, and grant a
seamless access to the video material in all active essences. The material ingested on an
EVS server must therefore, as much as possible, be and remain available on this server in
all active essences. For this reason, some restrictions or checks are applied when you
launch a configuration.
Change of Multi-Essence Configuration
To make sure the video material is available in the required essences on the EVS server,
you need to perform a clear clip before launching a configuration in the following
situations:
• after upgrading from Multicam 11.XX to Multicam 12.XX.
• in specific changes from one to another multi-essence configuration
See section "Clearing Video Disks" on page 40 for detailed information on when a clear
clip is required.
How to Manually Launch a Configuration
In the Server-Based Application
To start a configuration in the server-based application, proceed as follows:
1. Press the UP ARROW or DOWN ARROW key to respectively move up and down in
the list of configuration lines until the requested line is highlighted.
2. Press ENTER to run the configuration line on the EVS server.
In the Web-Based Interface
To start a configuration in the web-based interface, click the Launch icon next to the
configuration line you want to launch.
12 2. Multicam Setup
EVS Broadcast Equipment SA Issue 12.02.C - April 2014