EVOnet network camera, Руководство пользователя

Страница: 13 / 74

Network Camera
7
 Side Cable Access Hole, Cable Access Hole : Allows you to feed wires and cables for
connection to power, devices, and Ethernet.
 Safety Wire , Safety Wire Setscrew Hole : Allows you to connect the safety wire to the dome
cover and to the bottom cover by using the screw provided with the camera. It prevents the dome
cover from falling when it is separated from the camera body.
 Dome Cover Setscrew , Dome Cover Setscrew Hole : Allows you to connect the dome
cover to the camera body.
 Shield Case : Hides the inside and prevents infrared from being reflected (IR LED
non-supported model only).
 IR LED : The sensor in the middle of IR LEDs detects low illumination and the IR LEDs are lit at
night or under low lighting conditions (IR LED supported model only).
 Lens
: Varifocal auto-iris lens is installed.
 Heater : Allows the camera to operate in a sub-zero temperature (Heater supported model only).
It operates with 12 VDC power only.

Rotation Base
: Allows you to adjust the rotation angle by turning the rotation base clockwise
or counterclockwise.
 Pan Base : Allows you to adjust the pan angle.

SD Memory Card Slot:
Insert a micro SD memory card (SLC (Single Level Cell) or MLC
(Multi Level Cell) types of SanDisk or Transcend brands recommended).
 Factory Reset Switch: Use to return all settings to the original factory settings. See below for
details.
 Wall/Ceiling Mounting Holes : Allows you to screw the camera to the wall or ceiling.
 Bottom Cover : Allows you to mount the camera to the wall or ceiling.

Input/Output Device Ports
: Allows you to connect the input/output device. See the section
below.
 Tilt Adjustment Screw : Allows you to adjust the tilt angle.
CAUTIONS:
 Do NOT remove the SD memory card while the unit is operating; otherwise, the
system might not operate properly and recorded data saved on it might be damaged.
 SD memory cards are expendable supplies. After a certain use in time, partial
memory sectors can be damaged and recording may not be available or data will
be lost. Check the SD memory card periodically and replace it with a new one
if necessary.
Factory Reset
This will only be used on the rare occasions that you want to return all the settings to the original
factory settings.
CAUTION: When performing a Factory Reset, you will lose any settings you have
saved.