evertz 5600MSC Series, Инструкция по эксплуатации

Страница: 72 / 128

Model 5600MSC Master Clock/SPG Manual
Page 3-30
Revision 1.6
OPERATION
For example if the Colour Frame is 2, V Phase is 255, H Phase is 7 and fine phase is 0.0% then while
adjusting the H Phase upwards by 3 steps, the display will show
2 255 8 00.0
2 255 9 00.0
2 255 10 00.0
and then will return to
S1 h phase = 10
3.6.3. Configuring the Analog Video Test Generator Output (STG Option only)
3.6.3.1. Selecting the Standard of the Analog Video Test Generator Output
OUTPUT
ANALOG TEST GEN
ATG Standard
ATG NTSC-M
ATG PAL-B
This menu item sets the output format of the analog video test generator
output.
3.6.3.2. Setting The Phase of the Analog Video Test Generator Output
The Analog test signal outputs will all have the same phase and can be adjusted independent of the
analog colour black, and SDI and HD SDI test signal outputs. There are four registers that are used to
set the phase of the Analog Test Generator output. Figure 3-9 and Figure 3-10 show the default video
sync alignment for 59.94 Hz and 50 Hz systems respectively.
"
The front panel display will show
WARNING LIVE CTL
for 0.6 seconds to indicate
that adjusting the Analog Test Generator output phase menu items will affect the
phasing of the Analog Test Generator output immediately. You do not have to
press the SELECT button to accept the new values. Use these controls with
caution, as they will affect the overall timing of devices connected to the Analog
Test Generator output.
OUTPUT
ANALOG TEST GEN
ATG Col’r Frm
ATG col’r frm = 1
This menu item is used to set the phase of the video output in whole frames
and is usually used to align the colour frame sequence in PAL and NTSC
systems.
OUTPUT
ANALOG TEST GEN
ATG V Phase
ATG vert ph = 1
This menu item is used to set the phase of the video output in lines.
OUTPUT
ANALOG TEST GEN
ATG H Phase
ATG hor Ph = 1
This menu item is used to set the phase of the video output in samples.
USO
RESTRITO