evertz 5600MSC Series, Инструкция по эксплуатации

Страница: 107 / 128

Model 5600MSC Master Clock/SPG Manual
TECHNICAL DESCRIPTIONOPERATION
Revision 1.6
Page 3-65
GENERAL
ENG/USER MODE
Set user mode
ARE YOU
SURE?
When the 5600MSC is in engineering mode the ENG will be flashing.
Press the
SELECT key to change to user mode. The display will say “Set
User Mode. ?”. Press the SELECT key. There will a prompt. “ARE YOU
SURE?” Press the SELECT key to confirm that you want to change to user
mode. The 5600MSC will return to the ENG/USER MODE menu item with
the USER flashing. Press the ESC key twice to return to the ENG/USER
MODE menu item. Once this is selected, a password will be required to
return to USER MODE.
GENERAL
ENG/USER MODE
Enter Password
When the 5600MSC is in user mode the USER will be flashing.
Press the
SELECT key to change to engineering mode. A password is
required to change to engineering mode. Press the SELECT key again to
enter the password using the numeric keys. Passwords can be from 1 to 16
digits. Press the
SELECT key when you have finished entering the
password. If you have entered the correct password the 5600MSC will
return to the
ENG/USER MODE menu item with the ENG flashing. If you
enter an incorrect password you will return to the ENG/USER MODE menu
item with the USER flashing.
3.7.9. Saving and Storing 5600MSC Presets
GENERAL
PRESET SAVE/GET
Save Preset 1
Save Preset 2
Save Preset 3
Get Preset 1
Get Preset 2
Get Preset 3
Get USA Factory
Get EUROPE Fact
This menu item is used to save and recall (get) the configuration of the
5600MSC to one of three user presets. In addition you can recall various
factory preset configurations that closely match your desired application.
To save the entire configuration of the unit to the Preset 1 non-volatile
memory location select
Save Preset 1 , and then press the SELECT key.
There are two other user preset locations that can save alternate locations.
The
Save Preset 2 , and Save Preset 3 menu choices work the same way to
save configurations to these preset locations.
To recall all the information from Preset 1, and use it to configure the unit,
select
Get Preset 1 and then press the SELECT key. There will be 2 levels
of prompt. “ARE YOU SURE?” and “VERY SURE?” This is because the
current configuration will be replaced. Press the
SELECT key to confirm
each prompt. Pressing any other key will terminate the preset loading. The
Get Preset 2 , and Get Preset 3 menu choices work the same way to recall
configurations from the other two user presets.
The
Get USA Factory and Get EUROPE Fact menu choices work the same
way as Get Preset 1 , but retrieve one of the factory settings.
Get USA Factory sets all the outputs to NTSC rates wherever possible.
Get EUROPE Fact sets all the outputs to PAL rates wherever possible.
"
Using any GET may change any of the settings of the 5600MSC. It may disrupt the
timing of all the sync outputs, and the LTC and VITC timecodes and therefore must
be used with caution.
USO
RESTRITO