EVBox BusinessLine, Руководство по установке и пусконаладке

Страница: 40 / 46

Problem Possible cause Solution
LED ring shows blue for a few
seconds, then changes to yellow.
Vehicle will not
charge.
• Make sure that the minimum
current accepted by the car is
not higher than the minimum
current supplied by the station.
(Check by user.)
• Check the line-to-line and
neutral-to-line voltages at various
locations on the power circuit(s).
• Check that the electrical
installation is correctly grounded.
Charging station does not start
charging. LED ring flashes green for 30
seconds, then flashes red 10 times.
LED ring changes to green or goes off.
No response
from the
backend portal
account.
Use the card again to start the
charging. If the problem remains,
contact your operator or service
provider for further support. (Check
by user.)
Plug not locked.
• Is the plug pushed far enough
into the charging station? (Check
by user.)
• Examine the plug for damage or
bent pins. (Check by user.)
• Examine the socket to see if it is
blocked by an object. (Check by
user.)
Vehicle not
connected. Is the plug properly connected to the
vehicle? (Check by user.)
Charging station
lock is blocked.
Check if the charging station internal
wiring harness blocks the plug
locking mechanism.
Plug cannot be removed from
charging station.
Incorrect card
used to stop
charging (LED
ring flashes
purple briefly).
Use the same card to stop charging
as to start charging. (Check by user.)
EN
5. Operation instructions
36