EVBox BusinessLine, Руководство по установке и пусконаладке

Страница: 27 / 46

1.
Radio ripple control receiver controlled by the DNO.
• The station operates normally when the relay is open.
• The station is switched off when the relay is closed.
4.2. Install charging station
When the installation area is prepared and the charging station mounting systems are installed you can
then install and connect the charging stations.
Compatibility
The EVBox BusinessLine (4th generation) is not compatible with earlier generations of the BusinessLine
charging station. Each Hub-Satellite installation must consist of the same generation of charging
stations.
4.2.1. Install the station
See the corresponding illustrations in manual B.
1. If the cover is installed, remove the cover or covers from the charging station.
Note:
A double socket charging station has two covers.
a. Use the hex key (supplied) or a socket wrench with a hex socket to remove the screws at the
bottom of the charging station.
b. Open the cover from the bottom and lift it off the charging station.
c. Put the cover front side up in a place where it cannot be damaged.
2. For a double socket charging station : Mount on a ground, floor or wall Combipole.
4. Installation instructions
EN
23