EVBox BusinessLine, Руководство по установке и пусконаладке

Страница: 38 / 46

Problem Possible cause Solution
Charging station does not react.
No power to
charging station.
• Check that the residual-current
device and circuit breaker on the
main power supply panel are on.
• Switch off the main power
supply, wait 20 seconds, then
switch on the main power supply
again.
• Check that the power supply
cable connected to the charging
station is live. The LED ring
green should show green.
Charging station does not emit clear
tone when switch is set to on.
• Small plugs
on the
controller
are not fully
pushed in.
• 230V
connections
are not
connected
correctly.
• Check that the circuit breaker
(RCBO) is on.
• Check for 230 V on the input
terminals of the controller.
• Ensure all wire and plug
connections are secure,
especially on the controller.
Residual current device trips
constantly.
Grounding error
in the charging
station.
• Examine electrical wiring for
damage. Replace damaged
wiring.
• Moisture or condensation on
electrical connections. Dry the
connections where necessary. If
necessary, repair seals on
charging station
Fault in the
vehicle or
defective
charging cable.
Replace the charging cable.
Ground
resistence is too
high for the
vehicle type.
Measure the ground resistance and
compare it to the resistance required
by the supplier of the vehicle.
EN
5. Operation instructions
34