EVBox BusinessLine, Руководство по установке и пусконаладке

Страница: 33 / 46

c. Put the top of the cover over the top edge of the charging station frame and then pull the
cover downwards.
◦
Make sure that no wires are trapped around the edge of the cover.
◦
Make sure that the cover locks onto the frame and the rubber seals are in position to
ensure protection against water and dirt.
Note:
A double socket charging station has two covers.
d. Tighten the bolts at the bottom of the cover using a 5 mm hex key or a socket wrench with a 5
mm hex socket.
e. For a double charging station install the second cover in the same way.
3. Install a cover label set on each cover.
BusinessLine is ready for commissioning.
CAUTION:
Do not switch on power to BusinessLine at this time. You must first register BusinessLine with the
CMP before power is switched on.
4.3. Commissioning
Commissioning BusinessLine connects it to a Charging Management Platform (CMP), ready to charge a
vehicle. In a Hub-Satellite installation, only the Hub BusinessLine is connected to the CMP, with the
Satellites connected through this Hub using RS485 data communication.
A Hub model can connect up to 20 connectors (1 Hub and 19 Satellites, each with two connectors) to a
CMP. The Hub uses either a pre-programmed SIM to connect to the CMP through a cellular network, or
a Wi-Fi connection to a local Wi-Fi router.
Note:
It is important that BusinessLine is first registered with the CMP before power is supplied. This
allows BusinessLine to find and connect to the CMP URL automatically.
4. Installation instructions
EN
29