EVBox BusinessLine, Руководство по установке и пусконаладке

Страница: 28 / 46

a. Lift the double socket charging station onto the Combipole, feeding the power cables and
optional RS485 communication cables through the back plate of the station.
Note:
A double socket charging station can have one shared power cable or two separate
power cables, and may have RS485 communication cables for Hub-Satellite and Smart
Charging communication. During installation, feed the power and RS485
communication cables through the backplate of the charging station to which the
cables will be attached.
b. Make sure that the charging station slides fully down the pole to rest on the internal stop
inside the charging station.
c. Route the ground cable from the ground terminal block to the Combipole grounding point.
d. Align the grounding point in the station with the pre-drilled grounding hole in the Combipole.
Connect the ground cable to the grounding point with the 4 mm bolt and washer (supplied).
e. Disconnect the connectors from the right side of the controller.
f. Loosen but do not remove the bolts attaching the controller to the bracket.
g. Move the controller up to release the bolts from the slotted holes in the bracket, then move
the controller to one side to access the attachment points.
h. Tighten the clamps with a socket wrench to secure the charging station on the Combipole.
i. Move the controller back into position on the four bolts.
j. Tighten the four bolts.
k. Connect the connectors to the right side of the controller.
3. For a single socket charging station : Mount on an Adapter Kit or on a Wall Spacer
Note:
The mounting of the station on an Adapter Kit or a Wall Spacer is the same.
• The Adapter Kit is used to mount the station on a Combipole.
• The Wall Spacer is used to mount the station on a wall.
a. Install the EVBox Adapter Kit on the Combipole, or install the Wall Spacer on the wall (see
Optional components on page 14 ). Adjust three bolts and washers on the Adapter Kit or Wall
Spacer to the correct distance to engage with the backplate of the station.
b. Lift the single socket charging station onto the Adapter Kit or Wall Spacer, feeding the power
cables and optional RS485 communication cables into the station.
Note:
When a charging station is installed on a wall, the recommended cable entry is through
a cable gland in the base of the charging station.
c. Disconnect the connectors from the right side of the controller.
d. Loosen but do not remove the bolts attaching the controller to the bracket.
e. Move the controller up to release the bolts from the slotted holes in the bracket, then move
the controller to one side to access the attachment points.
f. Tighten the three bolts to secure the charging station to the Adapter Kit or Wall Spacer.
g. Move the controller back into position on the four bolts.
EN
4. Installation instructions
24