Eurotech ZyWAN, Руководство пользователя

Страница: 30 / 130

ZyWAN - User Manual
30 110150-1001F
Initial Connection with Single PC
The ZyWAN typically comes factory loaded with default settings, which need to be configured for the network
on which it will ultimately be used. The instructions in the following two sections describe how to set up the
hardware and software necessary to perform this initial configuration.
Note:
Ethernet port ‘0’ is used in this section, which typically comes with standard settings of
address 192.168.1.1, subnet mask 255.255.255.0, and operating as a DHCP server.
In some cases, the ZyWAN may come factory loaded with different settings. The
instructions given here may or may not apply, depending on the customer
configuration.
The simplest way to start the ZyWAN and perform an initial configuration is to use a direct connection to
another computer (PC). To make a direct connection, complete the following steps:
1. Connect the configuration PC using a crossover Ethernet cable.
2. Apply power to the ZyWAN.
3. Set up the PC’s network settings.
4. Configure the ZyWAN via its Web page.
The following sections provide detailed explanations of these actions.
1. Connect the Configuration PC
Connect a crossover Ethernet cable from the network port labeled ‘0’ on the ZyWAN to an Ethernet port on
the PC as shown in the following diagram.
Configuration PC
Crossover Ethernet Cable
ZyWAN
The crossover Ethernet cable may be purchased from Eurotech, or it may be obtained from a network
equipment supplier.
2. Apply Power
Connect the power supply to a wall outlet and to the 4-position power connector on the ZyWAN. See Power
Connector on page 16 for the power input socket pin configuration details.