EURA E2000-0004 S2B, Инструкции по безопасности и руководство по эксплуатации

Страница: 36 / 82

6) Operating panel
6) Operating panel
Inverter control, parameter setting, operating-parameter display and inverter-
status information are all done through the operation panel.
A seven segment, 4-digit display, combined with six button keypad field and
4-LED status line is build in on front of E2000+ inverters.
An optional build-in potentiometer is available
The adjacent picture shows the standard unit:
7-segment display, status
LED and keypads
7-segment display:
The content of the display can be configured, to show different operating
parameters, while inverter in STOP or START mode, error messages,
parameters and parameter values (for configuration see chapter:
Parameter group 100
– BASIC parameter)
The key is used to cycle through all programmed content, including
parameter level.
(Configuration parameter on display have always a leading F ).
Faults are displayed with the respective error code.
Flashing numbers in STOP mode indicate the target-frequency, which
the inverter will reach after START command is given.
Status LED:
To display the inverter status:
Inverter in START
mode. Display shows
the programmed
working parameters
To indicate the rotating
direction
Toggle with key,
if ON, single step modus
is
selected for
parameter cycling
ON, if the number on
the display corresponds
to output frequency
Key and function
Cycling through
STOP command
Toggle Parameter: Increment /
different display START command
switch for Selection, and save Decrement Key
content
ERROR RESET
E2000+_Rev.02 -E-SOFT Rev. 5.09
- 31 -
© 2016-06-KPP-EURADRIVES EUROPE GmbH