EURA E2000-0004 S2B, Инструкции по безопасности и руководство по эксплуатации

Страница: 42 / 82

8) Parameter group 100: Basic parameter
0: Target frequency / Parameter ( F xxx)
1: Jog modus via keypad - HF-0
2: Target motor speed (rpm)
4: DC-voltage
F132 Display: Selection of operating
8: PID control feed back
16: Heatsink temperature
Default setting:
parameters to display during „STOP“ status
32: Counter
0+2+4
＝
6
(Motor stopped) 64: PID set-point
128: Reserved
256: Reserved
512: Torge control reference
1024: Reserved
2048: Reserved
With inverter in STOP mode, the display will always show the target frequency - flashing
Following table shows the units and display-mode for various parameters:
Motorspeed (rpm): ( NNNN ) integer value
– the decimal point indicates values above
9999. Motor Current A (A.A)
Motor-Voltage: U (VVV)
Counter status: ( ZZZZ )
DC-Voltage: u (VVV)
Heatsink temperature: H (TTT)
Calculated speed L(sss) . Decimal point to indicate values above 999, two decimal points for values above
9999 PID controller Set-Point (normalized): (o*.*)
PID Feed-Back (normalized): (b *.*)
Motor-Power (normalized): (x.x)
Motor-Torque (normalized): (m.m)
Single phase inverter size E1 (0.2 - 0.75KW) do not have temperature indication.
Parameter, for calculated speed indication (display)
F133 Transmission ratio Range: 0.10 - 200.0 Default setting: 1.00
F134 Pulley diameter 0.001
– 1.000 (m)
Default setting: 0.001
Example: Max. Frequency F111=50.00Hz , number of poles F804=4 , transmission ration F133=1.00 , pulley diameter R=0.05m
( F134=0,05
), calculation result: pulley circumference: 2πr =2×3.14×0.05=0.314 (meter), shaft speed: 60×frequency / (number
of poles × transmission ratio) = 60×50/ (2×1.00) =1500rpm. For linear speed: speed (rpm) × pulley circumference =
1500×0.314=471(meter/second)
E2000+_Rev.02 -E- SOFT Rev. 5.09
- 37 -
© 2016-06-KPP-EURADRIVES EUROPE GmbH