[email protected] phone +39 0444 419762
www.esmach.com
p.
93
English
To modify the parameter P09 or P11, go to the user’s menu (see par. 3.3.5.6)
When the display (2) shows:
“_ d1” the parameter P09 is set up on “r” (see example below)
“_ d2” the parameter P11 is set up on “r”.
“d1_” the parameter P09 is set up on “A”.
“d2_” the parameter P11 is set up on “A”.
where: r = delay of distribution beginning compared to start
A = advance of distribution beginning compared to the end of the cycle scheduled
During the ingredient distribution, the acoustic alarm shall be activated for 5 seconds and the display (2)
shows “_d1” or “_d2” in an intermittent way
In the example shown below, the setting for D1 dispenser is the following:
« 5 minutes delay to start the ingredient dosage compared to the cycle start command ».
3.3.5.4
WATER DISPENSER
Check that the water pipe taps are running. To reach the water dispenser program, press the button (11)
the bowl cover has to be taken down), until the display (8) shows the letter “W”.
If no button is pressed after “W” displaying, the program of the previous mixture appears automatically after
30 seconds.
If after selecting the “W” program, the /- or the button (13) is pressed, the “W” mode remains
activated.
To go out from “W” selection, press the button (11), the system turns to the MANUAL program “
-
“
When the “W” program is selected, the blue led (20)
between the two displays (2) and (5) switches on.
The display (2) shows the number of litres to pour
into the bowl and to set up through the keys (3) and
(4).
The display (5) shows the number of deciliters to
pour into the bowl and to set up through the keys (6)
and (7).
To adjust the water temperature to put into the bowl,
turn the mixing handle control at the side of the
machine ( see picture 12, page 15) and at the same
time keep the button pressed (13) ( a by-pass valve
shall be activated allowing the water drainage
outside the bowl) until the value of the temperature is
shown on the display (19); in turning the handle
control clockwise, the water temperature decreases; it increases in counter-clockwise direction.
To start the water dosage, press the button (15) start.
The display (5) shows the value of the decilitres and the display (2) the value of the litres decreasing
progressively.
By pressing the button (16) stop, the water flow to the bowl is interrupted and the displays (2) and (5) blink.
By pressing the button (15) start, the water flow re-start from the point it had been suspended
11
8
20
2
5
13
19
15
16
9