Esko Kongsberg V-Series, Руководство пользователя

Страница: 72 / 144

12
Kongsberg V-series
For best performance and minimum wear, do
not let the bit stick out more than necessary .
Never use higher RPM than recommended by
the bit supplier.
Special care should be taken when using bits
with cutting diameter larger than shank
diameter .
Bits with small cutting diameter (3-4 mm;
0.12-0.16 in) are more balanced than bits with
larger cutting diameter
Thus, they can run with higher RPM, normally
60.000.
Use large diameter bits (5-6 mm; 0.20-0,24 in)
when needed only.
Typical use is to get rid of the chips in thick
materials.
Max RPM (MultiCUT-HP) 60.000.
Router Bit Edges are brittle.
Never let bits touch each other, or other hard
surfaces.
Always store in proper container.
72