12
Kongsberg V-series
Tool Offset
Adjust offset to
Laser Pointer
.
For more information about how to run the adjustment wizards, see
Tool Configuration
.
Notes regarding
Tool Height
adjustment:
When properly adjusted, the router bit should barely touch the top surface of the material.
12.6.12 Table Top and Height Adjustment
The following rules apply when adjusting MultiCUT/MultiCUT-HP
T = Cutting table, C = Cutting underlay
Map Table Top
function is carried out on top
of the Cutting underlay.
U = Milling underlay
The
Table Top Reference
function is carried
out on top of the Milling underlay
M = material to be processed
Tool Height Adjustment
is carried out on top
of the actual material or on top of any other
"test" material.
Note: This adjustment can be completed
both on surface U and M (not on C), but we
recommend the described solution.
The following rules apply when milling
Mill on cutting underlay (C):
To avoid damage to the cutting underlay, the
downward movement of the drill-bit is stopped
2 mm / 0.08 inch above the cutting underlay.
Thus, it is not possible to mill through the
material in this case.
Tool height will follow the mapped tabletop.
82
