12
Kongsberg V-series
7
The
Taper Brush
must be absolutely free from
grease or oil.
If necessary, you must clean it with alcohol
before you use it.
This is very important, as it has direct
consequence for the clamping force.
8
Apply small quantities of grease to the threads
of the
chuck
, and to the outer cone and
cylindric surface of the chuck (green arrows).
Avoid the clamping area (red arrow).
Do not use oil, as it could enter the clamping
area and reduce the clamping force.
9
Torque up the chuck by hand, using the
Chuck
Tool
with a
Dummy Bit
.
Hold the rotor with the 17 mm key.
10
Close the
chuck
on a
Dummy Bit
.
79
