18
Kongsberg V-series
After cutting, the design is difficult to remove from waste
Check tool height
After cutting, the corners are still fixed to the waste
Check tool lag
Bad quality in cutting, paper/cardboard tears
Check rotation of the tool
Offset in cut/crease lines
Check tool center offset
Offset between cut lines and crease lines
Check tool offset
Machine is milling in the carpet and table top
The milling bit is lowering inside the
Chuck
. Please fix the
Chuck
with the appropriate tool.
Milling: “Inverter not started yet”
After touching the safety unit, you need to wait for 10 seconds after resetting safety for the
milling inverter to activate
If problem persists, check the connection at the tool head of the milling spindle. Is the big
green cable still well connected?
Check all connections of the milling spindle: at tool head, inside cover X1 and at the inverter
Check serial connection between inverter and PC: connection OK? COM port changed lately?
If problem still persists, contact Esko
2 or 3 tools are working at the same time
Check your compressed air, make sure you have 7 bar
Check compressed air connection at the head. Is it well connected or is it leaking air?
Machine is milling in the milling underlay
Check vacuum zones. Are all necessary zones open? You can close non-covered areas to
strengthen the vacuum.
Check the force of the vacuum cleaner. It happens the vacuum cleaner is heightening the
milling carpets. Try to adjust the force by using the regulator on the spindle / vacuum cleaner.
18.3 iPC
iPC doesn’t want to make connection with the machine
Make sure you first switch on the machine and then iPC, not the other way around
143
