EsiWelma Sensigas EW40, Инструкция по установке и эксплуатации

Страница: 44 / 96

Type / N.
Rev. Data Page Total pages
EW095.605 5 November 2010
44 96
EsiWelma
s.r.l.
When a gas detector exceeds the set pre-alarm threshold (PR) or threshold one alarm (1t)
or a threshold two alarm (2t), the corresponding relays of the assigned relay module are
commanded.
To move the screen horizontally, press
To move down, press
To move up, press
For example, for the fifth detector to assign, move the pointer to the right as shown below.
Press ESC to confirm the associations and return to the “main menu”.
After the sensor association operation is complete, interface the alarm modules, if included,
otherwise the system can be considered operational.
NOTE
If a system does not include the installation of relay modules and display modules,
the "ASSIGNMENT" panels are not active. In any case, all the gas detectors
installed, without exception will be assigned to the relay module inside the control
unit (RM0)
M A I N M E N U
I N S T A L L A T I O N S T A T E
S E N S O R L I S T
E X P I R E D S E N S O R L I S T
Fig. 6.26
S 0 1 S 0 2 S 0 3 S 0 4
R M 0 1 “ “ “ “
R M 0 2 “ “ “ “
D M 0 1 “ “ “ “
Fig. 6.24
S 0 1 S 0 2 S 0 3 S 0 4
R M 0 1 “ “ “ “
R M 0 2 “ “ “ “
D M 0 1 “ “ “ “
Fig. 6.25
Press the key
indicated above to
move the pointer to
the right