EsiWelma Sensigas EW40, Инструкция по установке и эксплуатации

Страница: 62 / 96

Type / N.
Rev. Data Page Total pages
EW095.605 5 November 2010
62 96
EsiWelma
s.r.l.
press down the two
keys together for 5
seconds until you hear
a "BEEP"
For the DM, start from the main menu, go to the screen as shown in Fig. 8.20 and continue
as follows:
three times
With the cursor in the position as shown in Fig. 8.37 press “A" (DM active) is replaced by
“
DE ” (DM deactivated). Press again to force a temporary fail (FA) to physically identify
the device (status LED steady on).
Press once more to bring up the “A”, “DE”, “FA” sequence again.
After the tests are completed, press until the status screen disappears: any fail status
that is forced during the check will in any case be deactivated when leaving the screen.
CAUTION
Remember that if you leave the screen using ESC, any changes to the enablement
status will be confirmed (statuses “
A"
and “DE”); any fail status (“
FA
”) forced
during the check will in any case be deactivated when you leave the screen.
D M S T
0 1 A - - - - - - - -
Fig. 8.35
Q T P R 1 t 2 t F A
C H 4 3 - - - - - - - -
C O 1 - - - - - - - -
R M 1 - -
Fig. 8.32
Q T P R 1 t 2 t F A
D M 1 - - - - - - - -
A M 1 - -
- - - - - - - -
Fig. 8.33
Q T P R 1 t 2 t F A
D M 1 - - - - - - - -
A M 1 - - - - - - - -
- - - - - - - -
Fig. 8.34
D M S T
0 1 A - - - - - - - -
Fig. 8.36
D M S T
0 1
A - - - - - - - -
Fig. 8.37
Note that the setting cursor has
appeared