ESAB Aristo U82, Инструкция по эксплуатации

Страница: 29 / 96

4 MIG/MAG WELDING
0460 896 274
- 29 -
© ESAB AB 2013
4.3.1 Wire and gas combinations
For wire and gas combinations, see the "WIRE AND GAS DIMENSIONS" appendix at the
end of this manual.
4.3.2 Different pulsing methods
Below you can see which pulsing method can be used, depending on the plate thickness that
is to be welded.
Heat
Plate dimension
A = Pulsing in primary phase and short arc in secondary phase
B = Pulsing in primary phase and pulsing in secondary phase
C = Spray in primary phase and pulsing in secondary phase
4.3.3 Wire feed unit
Only use wire feed unit Feed 3004 during SuperPulse welding.
Precautionary measures!
When using SuperPulse, there is a considerable load on the wire feed unit. In order of the
functional safety of the wire feed unit not to be endangered, follow the limit values in the
following diagram.