ESAB Aristo U82, Инструкция по эксплуатации

Страница: 12 / 96

2 INTRODUCTION
0460 896 274
- 12 -
© ESAB AB 2013
2.6 General information about settings
There are three main types of setting:
• Setting of numerical values
• Setting with given alternatives
• Setting of ON/OFF mode
2.6.1 Setting of numerical values
When setting a numerical value, one of the two plus/minus knobs is used to increase or
decrease a given value. A number of values can also be altered from the remote control unit.
2.6.2 Setting with given alternatives
Some settings are made by selecting an alternative from a list.
Such a list might look like this:
Here the cursor is placed on the row for MIG/MAG. By pressing ENTER in this position, the
MIG/MAG alternative is selected. If you want to choose another alternative instead, position
the cursor on the correct row by stepping up or down with the left knob. Then press ENTER.
If you want to exit the list without making a selection, press QUIT.
2.6.3 Settings ON/OFF
For some functions, it is possible to set the values ON and OFF. The synergy function during
MIG/MAG and MMA welding is an example of such a function. The ON or OFF settings can
be selected from a list of alternatives as described above.
2.6.4 QUIT and ENTER
The “soft” key farthest to the right is used primarily for QUIT, although it is occasionally used
for other functions.
• Pressing QUIT entails moving back to the previous menu or screen.
The key is called ENTER in this manual.
• Pressing ENTER entails the execution of a selected choice in a menu or a list.