ES AWH11-V5+, Руководство пользователя

Страница: 15 / 86

2.4 Installation of the monoblock unit
2.4.1 Installation notes
1) The monoblock unit can be located in a open space, corridor, balcony, and roof.
2) The unit shall be placed in dry and well-ventilated environment;
3) unit mustn't be installed in an environment where volatile, corrosive or flammable liquid or
gas exists.
4) Please don't install unit close to bedroom or living room, because there is some noise when
it's running.
5) When installing the unit in harsh climatic conditions, sub-zero temperatures, snow, humidity..., please
raise the unit above the ground by about 50cm.
6)
Please ensure there is drainage system around the location, to drain the condensate water under
defrosting mode.
7)
When installing the unit, tilt it by lcm/m for rain water evacuation.
8)
9) Please don't install the indoor control unit and unit in damp locations, otherwise it may
cause short-circuit or corrosion of some components. The unit should be free from corrosive and
moisture surrounding. Otherwise the lifetime of the unit might be shortened.
10) Please ensure enough space around the unit, for better ventilation and maintenance.
Please refer to the illustration below.
monoblock monoblock
Monoblock
monoblock
monoblock
monoblock
monoblock
monoblock
monoblock
If the unit is
installed in humid environment, electronic components may get corroded, or short-circuited because of
heavy humidity.
It's recommended to install an awning above the unit, to protect the snow from clogging in
the air inlet and outlet and ensure the normal running.
Install unit far away from the exhaust port of kitchen, to avoid oil smoke entering
into unit and adhering to heat exchanger. It's hard to clean up.
2. Installation
15
≥
650mm
≥
400mm
≥
150mm(
）
Back space
≥
1500mm
(
)
Front
space
≥
500mm
≥
500mm
≥
500mm
( ) Above ground