Erreka VULCAN S, Руководство по установке

Страница: 54 / 96

Instalacion_77.fm -
27/5/13
INSTALLATION
50
Installation manual
Mount the operator on the front support
Mount the operator on the rear support
Mount the cover and the top
1
Introduce the operator ball bearing joint (1) in the
front support pin (2).

Before doing this, apply grease to the ball
bearing joint and the support pin.
2
Secure the ball bearing joint using the safety washer
(3).
1
Introduce the gudgeon (1) in the support (2).
2
Position the vertical pin (3), crossing the orifices of
the gudgeon and of the support.

Vertical pin:
ø
= 12mm, L = 37mm
3
Secure the pin using the safety washers (4).
4
Position the caps (5) to close the housing.
1
Introduce the rods (4) through the orifices of the top
(1) and the internal cover guides (2).
2
Thread the rods in the front top of the operator (3)
and tighten firmly.
3
Position the caps (5) in the holes in the top