Erreka VULCAN S, Руководство по установке

Страница: 58 / 96

Mantenimiento_77.fm -
22/7/11
54
Installation manual
MAINTENANCE AND DIAGNOSIS OF FAILURES
1
MAINTENANCE

Before carrying out any maintenance
operation, disconnect the device from the
power supply.
O
If you have to dismount the operator from its
supports, first tighten the discharge screw in
order to prevent the hydraulic fluid from
leaking.
1
Regularly check installation in order to discover any
imbalance or signs of deterioration or wear. Do not use
the device if any repair or adjustment is necessary.
2
Clean and lubricate the articulations of the gate, so
as not to increase the effort of the operator.
3
Check that the transmitters and photocells, as well
as their installation, have not suffered any damage
from the weather or external agents.
2
FAILURE DIAGNOSIS
3 SPARE PARTS

If the operator needs repairing, go to an
authorised assistance centre or manufacturer;
never try to repair it yourself.

Use only original spare parts.
4
SCRAP

The operator, up until the end of its useful life,
must be dismounted at its location by an
installer who is as well qualified as the person
who completed the assembly, observing the
same precautions and safety measures. In this
manner we will avoid possible accidents and
damage to adjacent facilities.
}
The operator must be deposited in the appropriate
containers for subsequent recycling, separating and
classifying the different materials in line with their
nature. NEVER deposit it in domestic rubbish or in
landfills which are not controlled, as this will cause
environmental damage.
Problem Cause Solution
The operator does not make any
movement when the opening or
closing transmitters are activated
Absence of system power voltage Re-establish the power supply voltage
Defective electrical installation Check that the installation does not
present any short-circuits or cut-off points
Defective control panel or control
devices Check these elements, seei ng their
respective manuals
Defective capacitor Check the state of the capacitor
By activating the opening or closing
controls, the operator is enabled but
the gate does not move The assembly dimen sions of the
supports have not been respected. Dismount the supports and then put them
back in place, respecting the assembly
dimensions
The gate moves in an irregular manner
The operator is not horizontal Dismount the supports and then put them
back in place, respecting the height
difference of 19 mm
The gate cannot completely close (or
open)
The photocell detects an obstacle Eliminate the obstacle and try again
T h e r e s i s t a n c e o f t h e g a t e h a s
increased when closing (or when
opening) Check the moving parts of the gate and
eliminate the resistance
The force of the operator during
closing (or opening) is too low U s e t he o p e n i n g a nd c l o s i n g f or c e
adjustment screws to increase the force
when opening and closing
The assembly dimen sions of the
supports have not been respected. Dismount the supports and then put them
back in place, respecting the assembly
dimensions