QuadroCS Manual II: Administrator's Guide
Administrator's Menus
Quadro
CS
(SW Version 3.0.x)
14
Numerous circumstances may cause a certain application on
QuadroCS to flag an event.
The page
Event Settings
lists all possible applications that
cause QuadroCS to raise events
and allows configuration of
notification (action), should one of these events take place.
Each entry in the events table has its checkbox assigned to the
row. By selecting the corresponding checkboxes, operations
such as
Edit
may be done for one or more events.
Edit
opens the page
Edit Event Settings
to modify the event
action.
Do Nothing
- Nothing will happen when the event occurs.
Display Notification
- A notification link will be displayed on
the bottom of all pages and a record is added into the
Events
table. The notification is executed as the link “Please Check
you pending events!” that leads to the page
System Events
.
This action also will take place if an action below (Flash LED
or Send Mail) has been selected, even if not selected
explicitly.
Flash LED
- the second LED (yellow) will be blinking once a
second and a notification will be displayed on the bottom of all
pages. For some events the LED will start flashing after a brief
delay.
Send Mail
causes sending an e-mail with a notification about
the new event and an event description in the mail body to the
e-mail address specified in the
Mail Settings
page.
Fig. II-18: Event Configuration Settings page
Actions that are not allowed for the selected event (like mail notification if the link is down or the mail server has been misconfigured) are hidden. For
multiple events editing, action which does not fit at least to one of the selected events will be hidden.
If QuadroCS cannot get an IP address from the DHCP server, or cannot register an extension on the SIP or Routing servers, or cannot reach an
NTP server, it raises only one event for the entire period the action has failed, but continues to try. When the required action is finally successful,
QuadroCS raises an appropriate event.
