Enerpac EBC20B, Инструкция

Страница: 18 / 28

18
Figure 15, Hydraulic System Maintenance
Figure 15B, Oil Reservoir Cap - Loosen (1) and
Tighten (2)
2
1
1
Figure 15C, Adding Oil to Reservoir Fill Hole (1)
1
2
3
4
Figure 15D, Diaphragm Cover (1), Diaphragm (2),
Diaphragm Opening (3) and Oil Reservoir (4)
Figure 15A, Oil Reservoir Cap (1)
1
9. Install and securely tighten the oil reservoir cap.
10. Using a clean rag, wipe the cutter housing, grip and
motor so that these surfaces are free of oil residue.
11. Insert the battery. Cycle the piston several times to
test for proper operation before placing the cutter
back into service.
10.5.3 Changing the Oil
NOTICE
The oil change procedure is very detailed and
will take a considerable amount of time. It should only be
performed by a trained technician at an Enerpac
authorized service center. Failure to properly perform the
procedure may result in incomplete filling of the cutter oil
reservoir, which could lead to cavitation, air entrainment,
reduced performance, and pump damage.
Change the oil in the cutter reservoir as described in
the following steps. Refer to Figure 14 and Figures 15A
through 15D:
1. Fill a clean oil dispenser with new Enerpac HF oil. Put
the dispenser aside for later use.
2. Procure a thick, soft metal bar (about 1/4 inch
[6.4 mm] minimum thickness). Put the bar aside for
later use.