Enerpac EBC20B, Инструкция

Страница: 15 / 28

15
Figure 13, Material Being Cut (typical - top view)
9.7 Additional Information
• Stop using the cutter when a noticeable decrease in
motor performance occurs. Continuing to operate
the cutter with a low battery charge increases the
possibility that the cutter may stop as a cutting
procedure is in progress.
• The cutter is designed with an electronic protection
system that will protect the battery against
overloading, overheating or deep discharge.
• The cutter will automatically turn off if the electronic
protection system engages. If this occurs, place
the lithium-ion battery on the charger until it is fully
charged.
• Refer to the battery and charger manual (published by
D
e
WALT ) for complete battery charging instructions
and important safety precautions.
Figure 12, Positioning Material Inside the Cutting Head
90°
90°