Enerpac EBC20B, Инструкция

Страница: 20 / 28

20
31. Be sure cutter is positioned so that the oil reservoir
cap is facing straight up. Do not operate cutter for
several hours (preferably overnight) to allow any
remaining air to separate from the oil.
32. Place the soft metal bar (refer to step 2) into the
cutting head.
33. Press and release the trigger in short bursts until
the piston is extended as far as possible, but before
it makes a full cut and retracts. The moving blade
will become lodged in the bar, preventing the
piston from retracting. This procedure is necessary
because the cutter mechanism alone may fail to
hold the piston in the partially extended position as
oil level is being checked in step 35.
NOTICE
If you cut completely through the bar, try
again, cutting as far as you can without making a full cut.
34. Remove the battery to prevent accidental motor
startup during the following steps.
35. Loosen and remove the oil reservoir cap. Recheck
the oil level in the oil drain/fill hole. If oil level has
dropped, add additional Enerpac HF oil until the oil
level is up to the top of the hole.
36. Install and securely tighten the oil reservoir cap.
37. Loosen the piston release screw to retract the
piston. If the piston is stuck, use the bar to manually
push the piston back until it retracts.
38. Using a clean rag, wipe the cutter housing, grip and
motor so that surfaces are free of oil residue.
39. Insert the battery. Cycle the piston several times to
test for proper operation before placing the cutter
back into service.
10.6 Cutter Blade Replacement
NOTICE:
WARNING
• Always remove battery from cutter before
beginning blade replacement procedures. Failure to
observe this precaution could result in accidental
startup during blade replacement. Serious personal
injury could result.
• Use extreme caution when removing and installing
blades. Blades may be sharp even when worn. To
avoid hand injury, wear appropriate personal
protective equipment (PPE) and avoid contact with
blade cutting edges.
10.6.1 Blade Wear
The use of worn blades decreases the effectiveness of
the cutter and can also side load the cylinder, resulting
in possible damage to the tool. Motor overheating can
also occur.
Replace blades immediately if they are worn and/or
damaged or if there has been a noticeable decrease in
cutting performance.
NOTICE
Blades are not sharpenable and must be
replaced when worn. To help ensure optimum cutting
performance, replace both the fixed blade and the
moving blade at the same time.