Enerpac EBC20B, Инструкция

Страница: 9 / 28

9
1 2 3
4
6
7 8
9
5
13
10
11
12
Figure 1, Features and Components
Key:
1. Cutting Head with Fixed Blade
2. Safety Guard
3. Piston and Moving Blade
4. Hydraulic Cylinder
5. Piston Release Screw 11. Grip/Handle
12. Trigger On-Off Switch
13. Storage Case 6. Positioning Handle
7. Lifting Eye
8. Oil Reservoir
9. DC Electric Motor
10. Li-Ion Rechargeable Battery
6.0 SET-UP
6.1 Delivery and Handling
The cutter is housed inside a protective storage case
which contains additional room for two batteries. If
ordered with the cutter, the batteries and battery charger
will be included in a separate package.
NOTICE
Always remove the battery from the cutter
before placing the cutter in the case. Always store the
cutter and batteries inside the case when not in use.
The cutter is designed for handheld operation. During
periods when cutting is not in progress, place the cutter
on a stable and level surface capable of supporting the
combined weight of the cutter and battery. Refer to
Sections 2.2 and 2.4 for weights.
6.2 Before Startup
• Be sure that the shipment includes all components
and that there is no obvious damage.
• Read the following sections of this manual to become
familiar with cutter features and safety devices.
• Fully charge the battery and install it on the tool. Refer
to Section 7.0 for battery information. For charger
operating instructions, refer to the separate battery
and charger manual (published by D
e
WALT).
NOTICE
Be sure that cutter piston is advanced as far
as possible before removing oil reservoir cap in the
next step. Oil leakage and improper operation may
result if this instruction is not followed.
• Advance the piston as far as possible, remove battery
from cutter and check the cutter hydraulic oil level.
Add oil if oil level is low. Refer to Section 10.5.2 for
detailed instructions.
• Be sure that the piston release screw is fully tightened.
Refer to Section 8.3.
• Before first use, remove air from the cutter hydraulic
system. Refer to procedure in Section 9.3.