32
Record stream to SD Card
Select this item and the Tampering Alarm recording will be stored in
Micro SD / SDHC card when tampering is detected.
Pre-trigger buffer recording function allows users to check what
happened to cause the trigger. The pre-trigger buffer time range is from
1 to 3 seconds.
Select <Upload for __ sec> to set the recording duration after tampering
occurs. The setting range is from 1 to 99999 seconds.
Select <Upload during the trigger active> to record the triggered video
until the trigger is off.
NOTE:
Please make sure the local recording (with Micro SD /
SDHC card) is activated so that this function can be
implemented. Refer to
Recording
for further details.
Send Message by FTP/E-Mail
The Administrator can select whether to send an alarm message by FTP
and/or E-Mail when tampering is detected.
Upload Image by FTP
Select this item and the Administrator can assign a FTP site and
configure various parameters. When tampering is detected, event
images will be uploaded to the appointed FTP site.
<Pre-trigger buffer> function allows users to check what happened to
cause the trigger. The <Pre-trigger buffer> frame rate could be
pre-determined.
On the other hand, <Post-trigger buffer> is for users to upload certain
amount of images after tampering is triggered.
Содержание PXD-1110F39
Страница 1: ...Full Manual 1 2 7 Full HD Network Dome Camera PXD 1110F39 PXD 1210Z03...
Страница 5: ...4 1 3 Dimensions The dimensions of the IP Camera are shown below...
Страница 6: ...5...
Страница 28: ...Menu Tree Ver 1 6...