7
2.
Camera Cabling
Please follow the instructions below to complete IP Camera connection.
2.1
Connect Power
For power connection, please refer to the
Connectors
section of the previous
chapter. Alternatively, connect the Ethernet Cable to the camera’s PoE port and
plug the other end of the cable into a PoE switch.
NOTE:
If PoE is used, make sure Power Sourcing Equipment (PSE) is
in used in the network.
2.2
Connect Ethernet Cable
Use of Category 5 Ethernet Cable is recommended for network connection; to
have best transmission quality, cable length shall not exceed 100 meters.
Connect one end of the Ethernet Cable to the RJ-45 connector of the IP
Camera, and the other end of the cable to the network switch or PC.
NOTE:
In some cases, Ethernet Crossover Cable might be needed
when connecting the IP Camera directly to the PC.
Check the status of the link indicator and activity indicator LEDs. If the LEDs are
unlit, please check the LAN connection.
Green Link Light indicates good network connection.
Orange Activity Light flashes for network activity indication.
2.3
Connect Alarm I/O
The camera equips one alarm input and one relay output for alarm application.
Refer to the alarm pin definition below to connect alarm devices to the IP
Camera if needed.
PIN 1: GND (Input-)
PIN 2: Input+
PIN 3: Output-
PIN 4:
Содержание PXD-1110F39
Страница 1: ...Full Manual 1 2 7 Full HD Network Dome Camera PXD 1110F39 PXD 1210Z03...
Страница 5: ...4 1 3 Dimensions The dimensions of the IP Camera are shown below...
Страница 6: ...5...
Страница 28: ...Menu Tree Ver 1 6...