Endress+Hauser Proline Promag L 800, Краткое руководство по эксплуатации

Страница: 23 / 56

Proline Promag L 800 Installation
Hauser 23
Screw tightening torques for mounting the Promag L sensor
Please note the following:
• The tightening torques listed below are for lubricated threads only.
• Tighten the screws uniformly and in diagonally opposite sequence.
• Overtightening the screws will deform the sealing faces or damage the seals.
• The tightening torques listed below apply only to pipes not subjected to tensile stress.
Tightening torques for:
• EN (DIN) →  23
• ASME →  24
• AS 2129 →  24
• AS 4087 →  24
Promag L tightening torques for EN (DIN)
Nominal
diameter
EN (DIN) Threaded
fasteners
Max. tightening torque
Pressure rating Hard rubber Polyurethane PTFE
[mm] [bar] [Nm] [Nm] [Nm]
50 PN 10/16 4 × M 16 – 15 40
65* PN 10/16 8 × M 16 – 10 22
80 PN 10/16 8 × M 16 – 15 30
100 PN 10/16 8 × M 16 – 20 42
125 PN 10/16 8 × M 16 – 30 55
150 PN 10/16 8 × M 20 – 50 90
200 PN 10 8 × M 20 – 65 130
250 PN 10 12 × M 20 – 50 90
300 PN 10 12 × M 20 – 55 100
350 PN 6 12 × M 20 111 120 –
350 PN 10 16 × M 20 112 118 –
350 PN 16 16 × M 24 152 165 –
400 PN 6 16 × M 20 90 98 –
400 PN 10 16 × M 24 151 167 –
400 PN 16 16 × M 27 193 215 –
450 PN 6 16 × M 20 112 126 –
450 PN 10 20 × M 24 153 133 –
500 PN 6 20 × M 20 119 123 –
500 PN 10 20 × M 24 155 171 –
500 PN 16 20 × M 30 275 300 –
600 PN 6 20 × M 24 139 147 –
600 PN 10 20 × M 27 206 219 –
600* PN 16 20 × M 33 415 443 –
* Designed acc. to EN 1092-1 (not to DIN 2501)