Endress+Hauser Micropilot M FMR231, Руководство по эксплуатации

Страница: 41 / 114

Micropilot M FMR231 with FOUNDATION Fieldbus Commissioning
Hauser 41
6 Commissioning
This chapter consists of the following sections:
• 6.1 Function check
• 6.2 Unlocking the device
• 6.3 Parameter reset
• 6.4 Commissioning with display and operating module VU331
• 6.5 Commissioning with Hauser operating software
• 6.6 Commissioning with FOUNDATION Fieldbus configuration tool
• 6.7 Commissioning with handheld terminal DXR375/FC375
6.1 Function check
Make sure that all final checks have been completed before you start up your measuring point:
• Checklist “Post installation check” (see chapter 3.5).
• Checklist “Post connection check” (see chapter 4.5).
6.2 Unlocking the device
Before commissioning, make sure that the device is not locked against parameter changes. On
delivery, the device is unlocked. In other cases, however, it may have been locked in one of the
following ways:
6.2.1 DIP switch (under the housing cover)
Locking and unlocking
L00-FMxxxxxx-19-00-00-en-002
WP = on: parametrization locked
WP = off: parametrization unlocked
SIM = on: simulation possible in Analog Input Block by configuration tool
SIM = off: simulation not possible in Analog Input Block by configuration tool
Parameters affected
Locking by the DIP switch affects all parameters.
EN DR
ESS
+HA US
ER
MIC RO
PIL OT I
I
HA
USER
MICR
OPILO
T II
IP 6 5 IP 65
Ord
er C ode : Ser.- No.:
Or der Code:
Ser .-No
.:
Mes sbe reich Mea
surin g ra
nge
Mes sbe reich Measu
ring r ang
e U 16 ...36
V D C
4...2
0 m A
U 16...36
V D C
4...20 mA max . 20
m
max.
20 m
Made in Ger
man
y Maulb
urg
Made in Ger
man
y Maulb
urg
T >70
°C :
A
t >8
5°C
T >70°C : A
t >
85° C
on
off
SIM WP
SIM WP
off
on
simulation
write protection
default settings:
write protection OFF
simulation ON (i.e. simulation is
allowed in the configuration tool)