Page 8
VSR-1200 Hardware Reference Module, Document 2
7
When the configuration has finished loading, press Escape until you return to the Main
Menu. (Go to
Section 2.4, Using the Main Menu
.)
8
To save the configured scenario (if it has not already been saved), do the following:
a
Write
the configuration. (See
Section 2.6, Saving (Writing) the Device’s Configuration
.)
b
Reset
the device. (
Section 2.7, Restarting (Resetting) the Device
.)
2.5.2
Device Addresses
To configure the device’s addresses, do the following:
1
On the Advanced Configurations menu, select Local Addresses.
2
On the Configure Local Addresses menu, select IP Address.
3
Enter the device’s IP address and press Enter. (Get the device’s IP address from your
network administrator.)
4
Select BANDIT Name.
5
Enter a unique name to identify this device in your network, and press Enter.
2.5.3
Ports
To configure software for the device’s ports, do the following:
1
On the Advanced Configurations menu, select Data Configuration.
❖
The Logical Port Protocol menu is displayed. (
Table 2-2
lists the Line IDs for the
ports.)
BANDIT Plus
Configure Local Addresses
----------------------------
1) IP Address : 192.168.169.1
2) BANDIT Name : BANDIT Plus
Enter Choice :
Table 2-2. Port Identifiers
(Sheet 1 of 2)
Line ID Physical (Hardware) Port Default Software Configuration
C
COM/Supervisor port
Comm/Supervisor
a
L
Ethernet LAN port
Ethernet
W
Ethernet WAN port
Ethernet
