VSR-1200™ and RDU™ Installation and Quick Configuration Guide
Page 5
a
To set up a basic configuration of the VSR for your network, select QuickStart Config
Builders
.
❖
The Startup Config Options menu is displayed. (On the next menu—the Startup
Configuration Scenarios menu—you can enter basic information; the VSR will use this
information to build a standard configuration.) Go to
Section 2.5.1, Startup
Configuration
.
b
To configure specific features, select Advanced Configurations.
❖
The Advanced Configurations menu is displayed. You configure most parameters of
the VSR from this menu. Go to
Section 2.5, Configuring the Software
.
2.5
Configuring the Software
For a standard, basic configuration of the VSR for your network, see
Section 2.5.1, Startup
Configuration
. For configuration of specific features, see the following sections.
•
Section 2.5.2, Device Addresses
•
Section 2.5.3, Ports
•
Section 2.5.4, Virtual Private Network Connections
•
Section 2.5.5, IP Configuration
•
Section 2.5.6, Simple Network Management Protocol
2.5.1
Startup Configuration
The menu provides several templates for configurations that your network may use. You can
select a template (also known as a startup scenario), change the scenario’s IP addresses and
related information to reflect the values in your network, and load the scenario into the VSR.
Note:
If you want the device to keep the configured scenario, be sure to write (save) the
configuration and reset the device.
Startup Config Options
-----------------------
1) SATELLITE
Enter Choice :
Advanced Configurations
------------------------
1) Physical Configurations
2) Data Configurations
3) Local Address
4) Routing
5) Global Paths
Enter Choice :
