VSR-1200™ and RDU™ Installation and Quick Configuration Guide
Page 7
c
If the item requests additional information, enter that information.
❖
When the item has been configured, the scenario’s menu is displayed again.
5
After you have performed
Step 4
for each item (parameter) in the menu, do one of the
following:
a
Select Load Above Config.
❖
The following prompt asks for confirmation. Go to
Step 6
.
b
Select Reset (Load, Write and Reset).
❖
The following prompt asks for confirmation. Go to
Step 6
.
c
Select Clear All Fields.
❖
The following prompt asks for confirmation.
• Do one of the following:
◆
If you wish to reconfigure, enter
Y
.
❖
All fields in the menu are reset to null values. Return to
Step 4
.
◆
If you do not wish to reconfigure, press Escape to return to the Startup
Configuration Scenarios menu.
❖
The configuration retains the settings you have entered, but they are not yet in use.
Return to
Step 4
.
6
To load the new configuration, enter
y
.
❖
The configuration is loaded into the VSR.
Note:
When you write (save) a configuration entered on the Quickstart menu, other
required settings are updated automatically. For example, when you enter the device’s
IP address, a path is automatically set up in the IP routing table to direct this IP
address to the device’s LAN port.
❖
If you selected Reset (Load, Write, and Reset), the configuration is also saved. This
makes the configuration permanent (unless you change it again). Then the device resets.
Caution: Existing configurations will be over written
Do you want to Continue?(Y/N)[N]:
Caution: Existing configurations will be over written
Do you want to Continue?(Y/N)[N]:
This Clears All the above Fields, Continue?(Y/N)[N]:
