Page 4
VSR-1200 Hardware Reference Module, Document 2
2.3
Logging In
1
On the PC, open a terminal-emulation session, such as HyperTerminal. Use the settings
in
Table 2-1
to establish communication between the terminal console and the VSR.
2
On the terminal console, press Enter to connect to the attached device.
❖
After successful log-in, the Main Menu appears.
2.4
Using the Main Menu
The Main Menu is displayed when you log onto the VSR. From the Main Menu, you can
configure and operate the VSR.
Note:
Whenever you wish to return to a higher level in the VSR menus, press Escape.
Caution:
The Supervisory connection to the device will time out after five (5) minutes
of console inactivity. If you have changed the device’s configuration and wish to use the
new configuration, save (write) the configuration before you leave the console. (See
Section 2.6, Saving (Writing) the Device’s Configuration
.)
1
On the Main Menu, do one of the following:
Table 2-1. Supervisory Port Communication Settings
Parameter
Value
Bits per second
9600
Data bits
8
Parity
None
Stop bit
1
Flow control
Hardware
Main Menu
----------
1) QuickStart Config Builder
2) Typical Configurations
3) Advanced Configurations
4) Tools
V) View Current Unit Status
L) Load Factory Defaults
P) Load Plug and Play Defaults
W) Write Configuration
R) Reset Unit
X) eXit Session
S) Statistics
Y) sYstem Administration
Enter Choice :
!
