Page 16
VSR-1200 Hardware Reference Module, Document 2
◆
Sample Phase 2 Proposal Menu:
4
Select the field whose value you wish to change, and press Enter.
❖
Possible values for the field are listed.
a
Enter a new value for the field, and press Enter.
❖
The field’s new value is accepted, and the proposal’s values are listed again.
5
Do one of the following:
a
To change another field’s value, repeat
Step 4
.
b
To return to the list of proposals configured for the selected phase, press Escape.
❖
The list of configured proposals is displayed again. Go to
Step 3
.
2.5.4.2
Configuring the IP/VPN Policy Table
You must configure the device’s IP/VPN policy. This policy includes gateway connection
information and the VPN profile that each connection uses.
If your connections will include VPNs across satellite networks, the BANDIT device will use
selective layer encryption. Before configuring the IP/VPN Policy Table, read
Section 2.5.4.3,
Selective Layer Encryption in VPNs
.
To configure the IP/VPN Policy Table, do the following:
1
On the Virtual Private Network Configuration menu, select IP/VPN Policy Table. (See
Section 2.5.4, Virtual Private Network Connections
.)
❖
The IP Policy menu appears.
2
On the IP Policy menu, do the following:
a
Select Status, and Enable the IP/VPN policy table.
b
Then select Policy Table.
❖
If the IP Policy Table does not yet have entries, it requests information for the first
record. Go to Step 6
b
.
❖
If the IP Policy Table already has entries, the table is displayed.
Phase 2 Proposal 1
---------------------
1) PFS : DH GROUP G2
2) Security Protocol: ESP
3) Encryption: DES
4) Authentication: HMAC-MD5
5) Life: 100 sec
6) Life Units: sec
Enter your choice:
