emmeti ETI 2100, Инструкция по установке и эксплуатации, Страница: 31 / 35

55 54
GB
The flashing of one of the 2 symbols indicates that the water
temperature (hot or cold) is not reached and causes the fan to stop
until the temperature reaches a value that is suitable to fulfil the
request.
The adjustment range is from 15 to 30°C, with a resolution of 1°C, but values outside the range of 5°C (Lo) and 40°C (Hi) are also allowed.
Set these values only for short periods and then adjust the selection to an intermediate value.
The command is very precise; bring it to the desired value and wait for the command to make the adjustment based on the actual room
temperature detected.
Activate the appliance by
Key Operation Display
mode
off
Press the mode/off key Off → On
mode
off
Select one of the 4 operating modes by pressing the relative mode/off key. In heating mode, the
symbols remain on with a setpoint higher than the room temperature; off with a lower setpoint. In
cooling mode, the symbols are on with a setpoint lower than the room temperature; off with a higher
setpoint.
Key Operation Display
Press and hold the Heating / Cooling key for about 2 seconds to switch the operating mode between
heating and cooling, visible through the activation of the 2 active heating or cooling symbols.
Key Operation Display
mode
off
Keep the mode/off key pressed for about 2 seconds. The absence of any luminous signal from the
display identifies the “stand-by” status (no mode).
On → Off
Key Operation Display
Use the two increase and decrease keys to set the desired temperature value displayed on the 2
digits of the display.
The supersilent speed will give rise to strong dehumidification in
cooling mode and to a radiant only function in heating mode (with the
fan off and the solenoid valve activated).
Setting the maximum speed, the maximum power that can be
delivered is immediately obtained in both heating and cooling.
Once the desired room temperature is reached, it is advisable to
select one of the other 3 operating modes to obtain better thermal
and acoustic comfort.
Key Operation Display
Every time the mode/off key is pressed, the fan speed changes between supersilent, minimum,
medium and maximum.
The activation of the function is signalled by the relative symbol on the display going on
LED indications
Heating / cooling operating mode setting
Stand By
Temperature selection
Speed adjustment