emmeti ETI 2100, Инструкция по установке и эксплуатации, Страница: 13 / 35

GB
13 12
FITTING THE CONDENSATE
DRAIN DEVICE IN THE VER-
TICAL VERSION
Connect the condensate drain
pan fitting (fig. 15 ref. A) to a pipe
for the flow of liquid (fig. 15 ref.
B) and block it properly. Check
that the drip guard extension
(fig. 15 ref. C) is present and
installed correctly.
FITTING THE CONDENSATE
DRAIN DEVICE IN THE HORI-
ZONTAL VERSION
Refer to the instructions found in
the BRC20/BRC100 kits to install
the horizontal pan on the ETM
versions.
- check that the L-shaped pipe
and the flexible rubber pipe are
connected correctly to the pan
(fig. 16 ref. A).
- insert the side of the machine
while keeping the pipe in po-
sition, in abutment on the front
grid.
- close the side securely, checking
that the pipe remains blocked in
the specific slot on the side (fig.
16 ref. B).
NOTE: abide by the following
warnings for a horizontal in-
stallation:
- make sure the machine is in-
stalled perfectly level, or with
a slight inclination towards
the condensate drain;
- insulate the supply and return
pipes well, up to the inlet to
the machine, so as to prevent
condensation from dripping
outside the drain pan;
- insulate the condensate drain
pipe of the pan along its en-
tire length.
16
A B
B
15
A
C
Ø 14 mm
Ø 14 mm