emmeti ETI 2100, Инструкция по установке и эксплуатации, Страница: 11 / 35

GB
11 10 10
HORIZONTAL OR CEILING-
MOUNTED INSTALLATION
Use the paper template to
trace the position of the two
fixing brackets and the two rear
screws on the ceiling. Use a
suitable tip to drill and insert
the plugs (2 for each bracket)
(fig. 13 ref. A); secure the two
brackets (fig. 13 ref. B). Do not
over tighten the screws.
Insert the machine on the two
brackets, keeping it in position,
then secure the two screws in
the rear plugs (fig. 13 ref. C),
one on each side.
It is recommended to apply an
adequate inclination to the unit
towards the drain pipe, so as to
facilitate the water output (fig.
13 ref. D).
Tighten all 6 fixing screws
securely.
The horizontal condensate drain
pan kit accessories are available
to install the
ETM versions
ETM BRC20 BRC40 BRC60
BRC80 BRC100.
13
A A
B
B
C D
HYDRAULIC CONNECTIONS
Piping diameter
The minimum internal diameter
that is to be complied with for the
hydraulic connection pipes varies,
according to the model:
ETM-ETI 220 ø12 mm
ETM-ETI 240 ø14 mm
ETM-ETI 260 ø16 mm
ETM-ETI 280 ø18 mm
ETM-ETI 2100 ø20 mm
For the position of the pipes for
the wall-mounted connections,
refer to the drawings in the
following paragraphs, based
on the specific configuration.