Emerson Rosemount, Справочное руководство

Страница: 15 / 252

5
Reference Manual
00809-0100-4021, Rev GC
Section 1: Introduction
April 2014
Introduction
1.2.5 Installation
When choosing an installation location and position, take access to the transmitter into
account.
Terminal side of electronics housing
Mount the transmitter so the terminal side is accessible, allowing adequate clearance for cover
removal. Best practice is to mount the transmitter with the conduit entries in a vertical position
to allow for moisture drainage.
Circuit side of electronics housing
Mount the transmitter so the circuit side is accessible, providing adequate clearance for cover
removal. Additional room is required for LCD display installation. The transmitter may be
mounted directly to or remotely from the sensor. Using optional mounting brackets, the
transmitter may be mounted to a flat surface or a 2.0 inch (50.8 mm) diameter pipe (see
“Mounting” on page 192 ).
1.2.6 Software compatibility
Replacement transmitters may contain revised software that is not fully compatible with the
existing software. The latest device descriptors (DD) are available with new field communicators
or they can be loaded into existing communicators at any Emerson Process Management
Service Center or via the Easy Upgrade process. For more information on upgrading a field
communicator, see
Section 3 .
To download new device drivers, visit www.AMSSuite.com.
1.3 Return of materials
To expedite the return process in North America, call the Emerson Process Management
National Response Center (800-654-7768) for assistance with any needed information or
materials.
The center will ask for the following information:

Product model

Serial numbers

The last process material to which the product was exposed
The center will provide

A Return Material Authorization (RMA) number

Instructions and procedures to return goods that were exposed to hazardous
substances
For other locations, contact an Emerson Process Management representative.
Note
If a hazardous substance is identified, a Material Safety Data Sheet (MSDS), required by law to be
available to people exposed to specific hazardous substances, must be included with the
returned materials.